solenoid.c

Go to the documentation of this file.

 
#include "solenoid.h"
 
void SolenoidInit(void) {
  /*
  __HAL_RCC_GPIOA_CLK_ENABLE();  // Enable GPIOA clock
 
  // Use Pin PA10 to toggle solenoid
  GPIO_InitTypeDef GPIO_InitStruct = {0};
  GPIO_InitStruct.Pin = GPIO_PIN_10;
  GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP;  // Push-pull output
  GPIO_InitStruct.Pull = GPIO_NOPULL;
  GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_LOW;
 
  // Set up interrupt
  HAL_GPIO_Init(GPIOA, &GPIO_InitStruct);
 
  // Init state of Solenoid
  SolenoidClose();
  Solenoid = SOLENOID_OFF;
  */
}
 
void SolenoidOpen(void) {
  /*
  printf("SOLENOID_OPEN: Setting PA10 to HIGH (Relay ON)\n");
  HAL_GPIO_WritePin(GPIOA, GPIO_PIN_10, GPIO_PIN_SET);  // HIGH = Relay ON
  Solenoid = SOLENOID_ON;
  */
}
 
void SolenoidClose(void) {
  /*
  printf("SOLENOID_CLOSE: Setting PA10 to LOW (Relay OFF)\n");
  HAL_GPIO_WritePin(GPIOA, GPIO_PIN_10, GPIO_PIN_RESET);  // LOW = Relay OFF
  Solenoid = SOLENOID_OFF;
  */
}